Dyson Airblade Wash+Dry

Call: +961 1 252 474

Airblade™ technology
in a tap.

Wash and dry
hands at the sink.

See it in action
Images

Features
Costs
Tech spec
Case studies
Range

The Dyson Airblade Tap hand dryer drying hands

No waste water on the floor

With Airblade™ hand drying technology in a tap, hands can be dried at the sink in just 14 seconds. There's no need for users to move to a separate drying area, so no waste water on the floor.

Free up your washroom

Other hand drying methods take up valuable wall and floor space. With the Dyson Airblade Wash+Dry hand dryer, there's room for extra toilet cubicles and other facilities.

Airblade™ hand drying technology in a tap

Every second, up to 21 litres of air are forced through apertures up to 0.55mm wide. The result – 549km/h sheets of air that scrape water from the hands, drying them hygienically in just 14 seconds.

Dyson Airblade Tap hand dryer costs compared to paper towels and other hand dryers

Saves you money

The Dyson Airblade Wash+Dry hand dryer costs an average of just $34 to run for a year. That’s up to 76% less than other hand dryers, and up to 98% less than paper towels. (see calculations).

$34

per year

to run

$140

per year

to run

$1,460

per year

to run

Learn more about costs

Airblade™ Wash+Dry

Paper towels

Other hand dryers

3.6 Grams

17.1 Grams

16.8 Grams

0 4.5 9 13.5 18

CO₂ produced per dry (grams)

Cuts your carbon footprint

The Dyson Airblade Wash+Dry hand dryer has a lower environmental impact than other hand drying methods. It produces 3.6g of CO₂ per dry - up to 79% less than other hand dryers and up to 79% less than paper towels (see calculations).

12 second dry time of a Dyson Airblade Tap hand dryer

Eases washroom congestion

The Dyson Airblade Wash+Dry hand dryer takes 14 seconds to dry hands completely. So users spend less time in the washroom, and busy periods are easier to manage.

Dyson digital motor technology

The Dyson digital motor V4 is one of the worlds smallest fully integrated 1000W motors. It spins up to 81,000 times a minute, and is the only hand dryer motor powerful enough to make Airblade™ technology possible.

Dries hands with clean air

Dyson Airblade Wash+Dry hand dryers uses a HEPA filter that captures 99.95% of bacteria and viruses from the air used to dry hands. So hands are dried with cleaner air, not dirty air.

HEPA filtration

The HEPA filter removes airborne particles from the air. It has a grille to capture larger debris, a fleece layer to capture fluff and fibres, and a pleated HEPA media to capture particles as small as 0.1 microns.

“Our mission is simple. We solve the problems others seem to ignore.”

James Dyson - Chief Engineer

Points to consider before installation

For more information please download a brochure.

Download brochure

Operating environment
Dry indoor environments only.
Maximum operating elevation 2000m.
Electrical supply
Dedicated 15 A supply per unit.
Input voltage/frequency 200-240V
50-60Hz

Rated power 1000 W.
Water supply
Water pressure between 1-8 bar.

Pipe thread 1/2" BSP
Clearance distance
Minimum 100mm distance between
floor and motor bucket.

Dyson Airblade Wash+Dry wall hand dryer must use metal enclosure as supplied